Loading ...
Sorry, an error occurred while loading the content.

460Servo Sweep

Expand Messages
  • topazx2
    Nov 1, 2010
    • 0 Attachment
      I have an arm on my robot that uses 4 GWS servos (non-modified), but when I test them with the setServo command, 0 - 100 doesn't service the entire sweep of the servo. I should be getting at least a 200 degree sweep, but the 0 - 100 limit only covers about 75 degrees.

      Is there anything that can be done to access a wider sweep?

      -Dan
    • Show all 9 messages in this topic