Re: wet again
- Well, story of my life, day late and dollar short. Obviously others
where thinking the same thing. The Pringle tops is a good thought but
one appeal of using a bandana or a sock is that it's not anything extra
to carry. I wonder if I have something in my kit that would work that
I already carry and could just be modified??? Hmmm
Water bottle cap, film case top, bra cup insert,
Also, how about putting a rock or two inside your sock then hanging
them on the line? That way it's weighted and you don't have to worry
about the wind whipping it around.
--- In email@example.com, "chcoa" <jdeben@h...> wrote:
> I don't know if this is what Bill was talking about with the "drip
> ring" idea but on my kayak paddles I have two washer type rings that
> sit right at the outside edge of my hands on the paddle handle. This
> greatly decreases the amount of water that run down the paddle handle
> on the up stroke. I'm thinking something like this might work for
> hammock ropes. One or two light weight washer type rings that fit
> tightly on the rope and instead of absorb the water they just
> it from running down the rope.
> Jamie in AZ
- I know I'm a little late wading in :~) on this topic but today is my
first day back from a 3 week kayak trip off Canada's west coast and
the subject is very relevant. The particular area we were in is
reputed to receive 324 inches of rainfall a year... and it felt like
they received all of that in the 21 days we were there!
At the last minute before departing, I butchered an old tarp to make
up some "end caps" and I'm very thankful I did (pic is in the album
Neale). I kept them rectangular so I could play around with shape and
configuration. The top corner of the caps tied off a few inches inside
the tarp peak and, for all the reasons discussed in this thread,
effectively prevented water running along the tarp ridgeline and
dripping over the hammock. I got no water blowing in the ends - and we
had gale-force winds on several occassions. Because they're not needed
all the time and I appreciated being able to adapt the set-up, I'm not
sure I'll actually attach them permanently to the tarp as I'd planned
but I'll certainly move to a more triangluar cut.
I tried cord and bandanas to wick the water from the HH hammock lines.
Both worked fine for me. I actually had more difficulty stopping the
flow down the tension lines for my JRB nest system. In future I'll
discard the stock suspension cords (I believe they're too long and
hang the quilt too low in rainy conditions) and use much shorter lines
to attach just upstream of the hammock-line joint. I eventually
discovered that using the snake skins to cover the lines until they
were under the tarp worked fine but I still got light moisture
travelling into the ends of the down underquilt. The other issue with
this solution was that I could no longer use the snake skins to furl
the hammock once they were wet - they'd certainly soak the hammock
during storage which would be a pain when expecting multiple days of rain.
My question to the group is this...
When we add the extras to stay dry and warm (ie. a separate tarp
requiring additional stakeouts rather than the HH integrated,
under-quilts, under-covers and end caps) - none of which goes into the
regular snake skins so each element requires just that little extra
time to put-up and take-down, are there ways to economize on the
time/effort required to set up? I was a whole lot more comfortable
than my tenting colleagues during this trip but then they were set up
and relaxing with a cup of tea a whole lot sooner than I was. It pains
me for the hammocks to be out-done on this one dimension. How can I
make hammocking even more virtuous by (radically?) shortening the set
up time? Tips? Techniques?