To Cat or not to Cat, was re:Tyvek
- Quieter pattern, ha ha, that's funny.
Did you ever get around to making one with a catenary ridgeline?
Anyone who has an opinion, please weigh in. Is a catenary ridgeline
better on a hammocking tarp? How much drop would you want?
Bill in Houston
--- In firstname.lastname@example.org, "Mirage" <mirage@p...> wrote:
> --- In email@example.com, "zippydooda"
> > Mirage,
> > How did the tyvek tarp work out? (I realize this is an ancient
> > thread.)
> > I found the link to your catenary cut tarp. Nice work. I'm
> > to make one in the next couple of weeks.
> Worked out fine, though I have only used it twice. It's noisy as
heck, even w/out the wind,
> so I think that is the greatest drawback. since making my SilNyl
tarps, I won't go back to
> I still have it, and used it for a while as a template for my
SilNyl ones, but I now use a
> paper pattern I made, it's quiter ;)
> Shane "Mirage"...
- Well, I actually find the hanging method to be quite easy. I use rolled kraft paper for my
patterns and a lightweight metal decorative chain purchased at a home improvement
warehouse. Instead of relying on a wall that's as long as I need for the curve, I have a 1" x
12" x 10' board that I use to put everything on (I store it against the wall behind the couch
in the living room so it's out of the way and out of sight when not in use). I cut the paper
into strips 10 inches wide (the paper comes in 30" width), and use 2 spring-loaded clamps
($3 each) to hold the paper to the board. Then I measure the center point, how far down I
want the curve to go, and mark where I want the chain to hang. Open one clamp slightly
and slide one end of the chain under it. Pull the chain until it is as taut as it needs to be
for the curve, stick it under the other clamp, and trace the line. Setup time is about 5
minutes and drawing the curve takes another minute. It's also very easy to adjust the
Not knocking the templates. I just wanted to share that it can be done easily with the
--- In firstname.lastname@example.org, "zippydooda" <zippydooda@y...> wrote:
> Having finally done this last night, I gotta say that the templates,
> or at least the X-Y coordinates, are the way to go. Being one who
> did not like the template idea, I hung the fabric on the wall, spent
> quite a while trying to get it level and straight and keep it from
> sagging too much between the support points, and all that, and then
> trying to dangle a rope, figuring out it was too heavy, and then
> dangling a thread so I could mark out some points and play connect
> the dots.
> It would have been MUCH easier to use the spreadsheet and then mark
> out several dots, and then connect them with the ruler.
> Gravity is NOT your friend - once you get the material off the floor,
> bad stuff starts to happen. In a fitting bit of irony, you get
> little catenary curves between your support points that cause
> headaches when you are trying to make your nice big cat curve.
> Now to sew along the line...
> Bill in Houston