Loading ...
Sorry, an error occurred while loading the content.

Re: webbing strength

Expand Messages
  • dlfrost_1
    ... not ... outter ... unison, or ... would ... designed ... strength ... Your description of unequal loading inside/outside is correct. But there is an
    Message 1 of 4 , Oct 31, 2005
      --- In hammockcamping@yahoogroups.com, "Dave Womble" <dpwomble@y...>
      > I always thought that rope strength was degraded with tight bends
      > (which knots do) that required the individual fibers to stretch at
      > significantly different rates. When that happens, the stress is
      > shared equally by all the fibers that make up the rope, with the
      > fibers at the bend taking on more of the stress and causing them to
      > fail first and at a lower stress than a rope without bends... it is
      > like all the fibers that make up the rope are not working in
      unison, or
      > parallel anymore. So applying that philosophy with webbing it
      > depend on how it is being reshaped. It seems like webbing is
      > to handle tight bends along its flat part but not so much along its
      > edge. But if you are just gathering webbing and rolling it into a
      > tubular position, I wouldn't think you would be degrading its
      > much, it at all.

      Your description of unequal loading inside/outside is correct. But
      there is an additional factor: The inner-radius segment of the line
      acts as a static bulk about which the outer segment is stretched in a
      levering action which amplifies the loading much further. If it
      weren't for this levering action rope would have a working load
      rating that's 33% of its maximum (as webbing does) rather than the 10-
      20% used currently. (You can also see why nylon is so superior for
      rope: The memory-stretch allows it to accommodate both the radius
      the levering problems much better than other fibers.)

      When rumpled, webbing only has the partial-loading problem to contend
      with, and so retains much of its strength. For example, a water knot
      loop in webbing retains about 75% of the webbing's total strength.
      When loops are properly sewn into webbing (i.e. X-box and oversewn)
      that figure is over 90%. (I also suggest that loops be 3 inches long
      after sewing so that any rumpling at the tie-off is smoothed out by
      the time it reaches the stitching.)

      Webbing's only weakness is wear. Because all of the fibers are
      exposed, it wears out faster than core-and-sheath ropes. On the
      other hand, you can easily see the wear, so inspection and
      replacement are not problematic.

      Doug Frost
    Your message has been successfully submitted and would be delivered to recipients shortly.