Loading ...
Sorry, an error occurred while loading the content.
 

Travis' file section

Expand Messages
  • Ole Jensen <ole_thor@yahoo.ca>
    Travis, a couple of notes on your diagrams in the files section 1 - cone device polarity there must be a ring of magnets on the inside of the barrel to support
    Message 1 of 1 , Jan 19, 2003
      Travis,
      a couple of notes on your diagrams in the files section
      1 - cone device polarity
      there must be a ring of magnets on the inside of the barrel
      to support each of the cones. the magnets will determine the
      size of the gap between the cone and the barrel. usually for
      ceramic 5 magnets, they should be about 1/8 to 1/16 inch apart.
      2 - isotope video. keep in mind when viewing this that the
      movement up and down for the lip of the cone is about 1/8 to
      1/16 inch. it is not nearly as pronounced as that video.
      3 - Hamel's tunnel - I'm not sure what this is about.
      4 - the GMD device - the outer rim magnets need to be slightly
      below the wing magnets to provide lift. take a couple of
      magnets and bring them together with like poles. then raise
      one slightly above the other and see that you can come closer
      that way, than if they are at the same height. this provides
      lift to the wings. it is the same in the 3 cone device. the
      outer rim of magnets is just a bit lower than the cone rim
      magnets to allow them to float.

      Ole.
    Your message has been successfully submitted and would be delivered to recipients shortly.