Re: [dxatlas] Re: Faros and Rig Timeout - PROBLEM RESTARTED
- Hi Barry,
Your polling and timeout settings are OK, the problem lies somewhere else.
73 Alex VE3NEA
----- Original Message -----
The timeouts have started again. Would adjusting the polling interval
or timeout settings help? My current settings are 500 and 4000,
73, Barry K4CZ
-- In firstname.lastname@example.org, "Alex, VE3NEA" <alshovk@...> wrote:
> Hi Barry,
> If your interface board does not support hardware handshaking, or
> does not have handshaking wires, then your DTR setting was most
> source of the problem. DTR=Handshake must be set only if there is
> support for that.
> 73 Alex VE3NEA
> ----- Original Message -----
> > I am using Faros with my TS-930, which has a Piexx board for computer
> > control. Faros and the TS-930 work together fine with one
> > exception. I've been running Faros for 24 hours and the TS-930
> > appears to timeout (freeze) every 1-2 hours.
> The problem has been fixed. I did the following: 1) reinstalled
> OmniRig to make sure I had latest version, 2) stopped running Hamcap
> and DX Atlas while running Faros, and 3) changed DTR setting to high.
> I'm not sure which change helped but Faros has been running more than
> 24 consecutive hours without any problems.
> 73, Barry K4CZ