Re: [dxatlas] Skimmer Newbie
In the Audio tab of the Settings window, have you select the EMU as
the "Signal I/O Device"? You should also select a valid "Audio I/O
Device" (which could be the EMU too).
~Iain / N6ML
On Sat, Nov 6, 2010 at 2:07 AM, k7eg <57JNDenneny@...> wrote:
> New to Skimmer and have setup issue. Skimmer is tracking K3 freq OK. I use LP-Bridge to link K3 (com 7 in) to Skimmer (com 9). Both ports are running at 38400 baud rate. When I attempt to start radio, I get error message: "A device ID has been used that is out of range for your system"
> Any ideas what to check? Skimmer settings:
> Audio MME
> CAT Use Radio 1 Elecraft K3
> Telnet: Port 7300
> EMU 0202 192K
> Jim K7EG
- Thanks Ian. I had not entered the audio device. Put EMU0202 in both boxes
and it's fixed. Now for SSCW.
[Non-text portions of this message have been removed]