Ham Cap 1.71
The application doesn't seem to be writing new parameters to the
configuration settings file on exit.
Every time it starts up it is back to the default settings. When I
change everything to my parameters it reads the pre computed
predictions OK without recalculation.
I'm running WinXP on drive D and have installed the app in a folder
on drive F, the same as it was with version 1.6
It links OK to IonoProbe and VOACAP both on drive F.
Well I changed the settings once more for a test and automagically
it wrote to the config file and the settings were saved.
The wonders of WinXP and my 10 year old Dell I guess.
All back to normal.
- Hi Mike,
Sorry for the late reply, I have just returned home and am working through
my email. I am not sure why HamCap would fail to save its settings without
complaining about a write failure. The settings are saved on program exit,
so perhaps the program failed to close properly and did not reach the point
where the settings would be saved. But again, one would expect some error
message to pop up if this happened. This is one of the mysteries of the ages
73 Alex VE3NEA
----- Original Message -----
From: "Mike Harris" <mike.harris@...>
To: "dxatlas_group" <firstname.lastname@example.org>
Sent: Tuesday, March 23, 2010 11:58 AM
Subject: [dxatlas] Ham Cap 1.71
> Well I changed the settings once more for a test and automagically
> it wrote to the config file and the settings were saved.
> The wonders of WinXP and my 10 year old Dell I guess.
> All back to normal.
> Mike VP8NO