Loading ...
Sorry, an error occurred while loading the content.

Re: Skimmer Server calibration?

Expand Messages
  • Wes Cosand
    Oops! When I tune the Ten Tec to the frequency Skimmer reports, the AUDIO is low so Skimmer must be reporting the spots a trifle high. WZ7I ... [Non-text
    Message 1 of 2 , Nov 5, 2009
    View Source
    • 0 Attachment
      Oops! When I tune the Ten Tec to the frequency Skimmer reports, the AUDIO
      is low so Skimmer must be reporting the spots a trifle high.

      WZ7I


      On Thu, Nov 5, 2009 at 10:30 AM, Wes Cosand <wes.cosand@...> wrote:

      > Folks:
      >
      > I easily got Skimmer Server going on a new QS1R and an Intel I7 box. It
      > has been running about 6% CPU utilization with 7 bands of 96khz going. It
      > will be fascinating to see how it does this weekend during Sweepstakes.
      >
      > My spots seem to be averaging about 200 hz low. Is there a way to
      > calibrate this so the signal is in the center of the bandpass? I assume
      > that since Skimmer Server loads its own FPGA code, that changes in the clock
      > speed in the SDRMaxII GUI would not make any difference. Is that correct?
      >
      > I think it has a good power supply on it. Voltage at the board are reading
      > 4.96V
      >
      > Wes
      >
      >


      [Non-text portions of this message have been removed]
    Your message has been successfully submitted and would be delivered to recipients shortly.