A question for Alex I think, unless anyone else can answer with
I'm working on getting Faros via OmniRig, to control and use an Icom
IC-PCR1000. This is for another user, and yet another person has
kindly loaned me a PCR1000 to work with.
So far, so good, I've got a driver that allows it to power it up,
configure it, set the frequency, mode, filter etc just fine, and the RX
seems to do the job.
But Faros is not happy, showing a Yellow Radio legend at the bottom left
of it's window. This indicates that Faros canot determine that the
radio's frequency is what was set. Indeed, it cant (for a good reason!)
The IC-PCR1000 cannot (as far as I can determine) report back it's
current frequency (& oh how I've tried!) Or for that matter, its
operating mode, or filter settings. A whole load of other stuff yes
(squelch settings, signal strengh, decoded DTMF etc etc) but not the
I'm also going to ask on the PCR1000 list about this too, in case there
is extra info about this radio, that I don't yet know, but of all the
info I have so far, none makes any menion about being able to read back
the working frequency.
I can see (using a serial intercept program "Bill Serial Monitor" truly
magic!) that Faros & Omnirig are sending the correct frequency, mode,
filter settings to the PCR, and also that the simple status poll is
working, but I cannot pursuade the thing to report back it's cuttently
set working frequency.
I've setup a simple Poll in the driver, so that OmniRig every 2 seconds
sends a 'H1?' query, and the radio returns a string indicating it's
powered up. The driver is configured to light up the 'RX' indicator in
OmniRig, if the Client is loaded too. That works fine. (Thinking,
querying the Squelch status would be more logical...)
As earlier, is there any way to configure Omnirig to report back the
same frequency an application set, or is there a way to set Faros to
ignore any frequency setting error?
Or, do I need to stoke up Delphi again, and craft an intermediary to
"pretend" to do all that.
Best Regards etc.