Re: [dxatlas] TS-570 vs OmniRig
- Alex and friends,
greetings from Manfred, DL1DWL, and a great 'thank you'for your help.
He switched RTS to handshake and everything runs as expected. Before
he used 'LOW' because other settings switched the radio to transmit.
73 de Eike, DM3ML
--- In firstname.lastname@example.org, "Alex, VE3NEA" <alshovk@...> wrote:
> Hi Eike,
> Kenwood radios have hardware handshake on their COM port. If the cable
> Manfred is using does not have the wires for the handshake signals, the
> corresponding pins may switch between the on and off state and cause
> intermittent problems.
> 73 Alex VE3NEA
> ----- Original Message -----
> From: "Eike, DM3ML" <dm3ml@...>
> To: <email@example.com>
> Sent: Friday, February 20, 2009 10:29 AM
> Subject: [dxatlas] TS-570 vs OmniRig
> I have been asked by Manfred, DL1DWL, to put this entry in the forum :
> Manfred tries to use a program from HB9MTN to control a magnetic loop
> by the frequency reading of his TS-570. The loop pogram uses OmniRig
> to read the CAT of transceivers. Everything (TX/RX switching, VFO A/B,
> mode control) works, only the frequency readout does'nt work. He
> tested the data exchange with client.exe. The status field jumps
> between 'online' and 'Rig is not responding'. He tested the right
> settings 4800 Baud and 8N2 with different polling times. With other
> CAT programs the control works as expected.
> Any advice for Manfred ??
> Thanks in advance an 73 de Eike, DM3ML