Re: Rocky 3.6 CW timing , QSK , Keyer voltage
- OK , Rocky is a fine software I really enjoy to use . I can understand
you use the soundcard latency as guard agains hot switching PA relay .
20mS should be enough for even an lazy relay. OK about QSK , again me
not thinking ;-) . You are absolutly right it is very easy to HW
compensate from the negativ DSR, CTS paddle/comport voltage , however
i would also think it was easy to code DSR,CTS as positiv voltage with
an idle (open) key . This way the software user could switch between
positiv or negativ key voltage . Also to be able to switch for
right/left hand (reverse paddle) ops in the CW console. Again much
more easy to make suggestions than actions ;-)
best vy73 de oz1bxn chris
--- In email@example.com, "Alex, VE3NEA" <alshovk@...> wrote:
> Hi Chris,
> The PTT line is switched on the paddle contacts closure only if the
> is enabled. PTT is set high as soon as the contacts are closed, the QSE
> output appears with a 20-40 ms delay, depending on the soundcard
> Because of this latency, QSK cannot be implemented in Rocky.
> You can use your own circuit to connect the paddle to the COM port. For
> example, you can use optoisolators and make the base of the paddle
> Unfortunately, solutions like this require a power supply, the
> on the Rocky web page doesn't.
> 73 Alex VE3NEA
> ----- Original Message -----
> From: "oz1bxn" <oz1bxn@...>
> To: <firstname.lastname@example.org>
> Sent: Tuesday, January 27, 2009 07:12 AM
> Subject: [dxatlas] Rocky 3.6 CW timing , QSK , Keyer voltage
> Hi , and thanks for a great software.
> However are there in the software made any room for sequencing to
> prevent hot switching a PA in connection with Rocksoft hardware.?
> If so how many mS from PTT goes high till CW carrier?
> Will we see QSK in Rocky?
> The Keyer voltage on the COM port is negativ , making is hard to use a
> Key with typical NPN transistor output. Any solutions for this ( other
> than that PNP transistor in the Keyer)
> best vy73 de oz1bxn,chris