Loading ...
Sorry, an error occurred while loading the content.

Re: Software for 3D DLP Printer

Expand Messages
  • yonray
    @Graham Ok, thanks for your input, i will look it up!
    Message 1 of 3 , Feb 2, 2013
    • 0 Attachment
      @Graham
      Ok, thanks for your input, i will look it up!

      --- In diy_3d_printing_and_fabrication@yahoogroups.com, Graham Stabler wrote:
      >
      > The B9creator is based on an Arduino, you might like to check out the
      > source code which can be downloaded from the website www.b9creator.com
      >
      > As for learning to program the Arduino I can't help, I'm a parallax
      > propeller fan but there are many forums all about the arduino where you can
      > learn what you need.
      >
      > Graham
      >
      >
      >
      > On Sat, Feb 2, 2013 at 12:06 AM, yonray wrote:
      >
      > > **
      > >
      > >
      > > Hi everyone, i plan to built a 3d DLP printer and i want to create a 3d
      > > dlp printing software that loads a power point slideshow and control each
      > > slide while communicating to arduino through serial to control z axis and
      > > tilt mechanism at the same time. The arduino is a great resource, if used
      > > properly a person can keep cost down in building and controlling outputs
      > > for a 3d DLP printer. I have very little programming knowledge for the
      > > arduino, and i am new to visual basic programming. does anyone know any
      > > great websites or books, that can lay the foundation necessary to attain
      > > one's goal?
      > >
      > > Your inputs will be greatly appreciated!
      > > Thank you!
      > >
      > > Rayon
      > >
      > >
      > >
      >
    Your message has been successfully submitted and would be delivered to recipients shortly.