Loading ...
Sorry, an error occurred while loading the content.

Re: Teflon glass will be in the mail to Junior by Friday

Expand Messages
  • bgriggstwcny
    Has anyone tried Frog Spit instead of Teflon to coat the glass? I have no experience with the material but it sounds interesting.
    Message 1 of 3 , Feb 7, 2011
    • 0 Attachment
      Has anyone tried Frog Spit instead of Teflon to coat the glass? I have no experience with the material but it sounds interesting.

      http://www.chemical-supermarket.com/Frog-Spit-Quart-p622.html

      Bill


      --- In diy_3d_printing_and_fabrication@yahoogroups.com, "Ian" <lone_cyclist@...> wrote:
      >
      > I have had some sticking problems with things before... if the teflon fails... a fluorosilacate coating might provide a better surface. In my experience with ferrofluids, wich are iron, kerosene and an emulsifier to make em really stick to things, fluorosilacates were the only thing they didn't stain.
      >
      > --- In diy_3d_printing_and_fabrication@yahoogroups.com, vrsculptor@ wrote:
      > >
      > > The process of getting the borosilicate glass and having it coated took a whole lot longer than I would have liked but everything is finally done. I've sent Junior a private email to get mailing information for him.
      > >
      > > If the teflon glass works and others want to use it we are going to have to set up a group buy of some sort. There is a minimum charge of $300 which should be sufficient to cover quite a few machines. There are size limitations on what can be coated.
      > >
      > > I hope this works. I really need one of these machines.
      > >
      > > Roger
      > >
      >
    Your message has been successfully submitted and would be delivered to recipients shortly.