Loading ...
Sorry, an error occurred while loading the content.

9431Re: Introduction and presentation of our 3D epoxy printing project.

Expand Messages
  • Brian Bauman
    Jun 13, 2014
    • 0 Attachment

      Even if you find the right initiators for proper UV epoxy curing you will need an acrylate blend to made sure green strength development is strong enough or you will have a pile of goop that will harden after a few minutes.  Of course this all depends on the optical power you have in the chamber. You also have to determine which wave length you will work with for the proper initiator species selection.

      There is not a lot of good resources in this area other then reviewing patents.

      Good luck.

    • Show all 12 messages in this topic