Loading ...
Sorry, an error occurred while loading the content.

9309Re: [diy_3d_printing_and_fabrication] Need help to diagnose print

Expand Messages
  • Graham Stabler
    Apr 5, 2014
      Plenty of people are printing perfectly well without doing that aren't they?



      On Sat, Apr 5, 2014 at 1:51 PM, Ben Mahony <ben.mahony@...> wrote:

      It is usual to have 'hot spots' where the projector  is brighter, you need to make a 'mask' image and overlay it with you output images to darken the bright spots, easier than adjusting the time.  Hope that helps.
      Ben M

      On 5 Apr 2014 17
    • Show all 21 messages in this topic