Re: Flip Flop Problems
- --- In email@example.com, "joshbensadon" <joshbensadon@y...>
> Ed,I'm guessing that Netscape must be recognizing the file as
> I am running win98, I downloaded it with Netscape 4.77 by
> right clicking and "Saving Target". Usually, it should be
> saved if I just double click it, but when I do this, it comes
> up with junk on my screen. Perhaps post it as a .zip?
being of a type that it can read and thus sets out to read
it without downloading. I have similar problems with *.sch
schematic files. Microsoft keeps wanting to treat them as
Microsoft Scheduler files.
- apendragn wrote:
> I copied the design for the clock for theShould work. You did tie the PRESET and CLEAR pins of the 74HCT74 high?
> Elf 03 from another design. This design
> used two inverters for a clock and then
> sent the signal through a D Flip Flop
> whose NOT Q output was sent back to the
> D input. According to the literature,
> the D flip flop should toggle when the
> clock input goes high. However, I did
> not see the clock signal get divided by
> two when I did it this way. Even though
> the input clock signal was fairly good.
> It had a frequency of 3.75 MHz, a high
> input over 4.5 volts and a low input of
> about 0.5 volts, still, the flip flop
> did not divide the signal by two when
> clocked. I used a 74HCT74 for the D flip
If you left them floating (which you could do with the old bipolar
parts, but not CMOS) or grounded them, it wouldn't work.
Lee A. Hart Ring the bells that still can ring
814 8th Ave. N. Forget your perfect offering
Sartell, MN 56377 USA There is a crack in everything
leeahart_at_earthlink.net That's how the light gets in - Leonard Cohen