- Every SUBARU engine is a flat -4 or -6 - and always water-cooled. Ultimately for the horsepower to get MT up on a plane no power plant will as light for theMessage 1 of 42 , Nov 16, 2012View SourceEvery SUBARU engine is a flat -4 or -6 - and always water-cooled.
Ultimately for the horsepower to get MT up on a plane no power plant will as light for the power as an outboard by the time you add up gearbox, shafting, propeller, pivoting of prop etc.
Susanne Altenburger, PB&F----- Original Message -----From: nezihSent: Friday, November 16, 2012 3:35 AMSubject: Re: [bolger] Re: MICRO TRAWLERSir,Any picture of the Engine,you saw in Fort Lauderdale in a Dunebuggy shop.Highly appreciatedNezih----- Original Message -----From: Douglas PollardSent: Friday, November 16, 2012 4:24 AMSubject: Re: [bolger] Re: MICRO TRAWLERI read someplace that the engine designer was an airplane designer. It sure looks like and airplane engine. Back in the 1980's somebody built a water cooled aluminum block to bolt on to the crank case in place of the air cooled jugs. They also had water cooled heads for it. I saw one of the engines in a Dunebuggy shop In Fort Lauderdale. That engine might well make a nice boat engine.
On 11/15/2012 09:00 PM, Mark Albanese wrote:
Yeh, it was great to have it and the transaxle balanced atop a rolling jack. The heat is what burned the valves out. I expect in a boat one may also seem pretty loud.On Nov 15, 2012, at 11:49 AM, Douglas Pollard wrote:What the engine had going for it was it could be dropped out for rebuilding in 15 minutes. Usually the valves were burned and new rings needed the lower end bearings and crank held up well... ...I would think it would make a far better engine for an air boat. In this case it can be standing above the boat where it can get free air circulation.Doug
On 11/15/2012 12:52 PM, nezih wrote:Yesterday,I have been informed that boat builders here are installing old VW Beetle Engines(after marinise)as Inboard Engine.They are not heavy,like outbards.I think this engine eliminates the weight problem of otherInboard EnginesAwaiting comments.Nezih
- True Doug, Ford FE gas truck engines had larger diameter crankshafts and cam profiles designed more for low RPM torque, compared to the equivalent car engines.Message 42 of 42 , Nov 16, 2012View SourceTrue Doug, Ford FE gas truck engines had larger diameter crankshafts and cam profiles designed more for low RPM torque, compared to the equivalent car engines. Some GMC truck gassers even had exhaust valve rotators and stellite valve seats, anticipating heavier engine load demands.Your Isuzu may have had oil starvation issues if the oilpan capacity was not increased and the pickup lowered. I have a marinized 1956 Packard V8 with the oilpan capacity increased from 5 quarts to 4 gallons and an integral oil cooler built in. Most working boats of 25-30 feet and up have gone diesel but that may not be a practical option for the MT being discussed. 4 cycle outboards have been around for several years now and have a good track record even in small commercial fishboats that get hard use.