- Bruce, ... I agree they will look better rounded. Reddy is mostly square angles, so the rectangular window frames aren t so bad. ... Yes, they work like aMessage 1 of 25 , Nov 2, 2003View SourceBruce,
>I agree they will look better rounded. Reddy is mostly square angles, so
> I don't regret the rounded
> corners, I like the way they
> look, but it *was* extra work.
the rectangular window frames aren't so bad.
>Yes, they work like a gusset. Much stronger frame corners, and I'd guess
> Also, I think that the rounding,
> [would you call that filleting?]
> also serves structurally with the
> connections of the stiles and rails,
> and that is probably the reason that
> the PB&F plans show them.
the rounded corner of the pane is stronger than a 90 degree corner...
>My current idea is the rails and stiles connected with half lap joints.
> > My intent is to fit the panes before
> > assembling the final stile, then
> > fitting the whole mess to the cabin.
> How will you connect the last joint?
> I found it easy to goober up the Lexan
> with glue, and it scratches too easily.
On the benchtop epoxy three sides together with the fourth dry fitted to
maintain shape. Next day slide in the pane with flexible goop in the
slots, epoxy on the fourth. Later bed and screw the whole thing to the
cabin, like when a house gets new windows....
What I'll actually do, who knows? I'm open to suggestions.
Last two goes at this sort of thing I left the paper on the panes until
very close to launching day.
- ... In my case, dealing *neatly* with the goop, [siliconized caulk] was *not* easy. I predict that sliding the windows down a slot, will be messy, and willMessage 2 of 25 , Nov 2, 2003View Source--- sctree wrote:
> slide in the pane withIn my case, dealing *neatly*
> flexible goop in the slots,
with the goop, [siliconized
caulk] was *not* easy.
I predict that sliding the
windows down a slot, will
be messy, and will push
the goop out when you want
to keep the goop in.
I recommend lots and lots
of masking tape, plus maybe
you should experiment some
first. I found that making
about a hundred 'single use'
"V" scraper tools out of
thin cardboard worked to lift
and clean the over-gooped
caulking. Each was used for
about four inches, and then
You might also want to consider
a more conventional window
glazing detail, where you use
a trim piece instead of a slot.