Loading ...
Sorry, an error occurred while loading the content.

Re: tool inserts

Expand Messages
  • Nick Hull
    ... I use TNMG, I made a toolholder with a 7 deg droop at the nose so the TNMGs then have an automatic 7 deg relief. Works for me and I get 6 cutting points.
    Message 1 of 4 , Jun 30, 2005
    • 0 Attachment
      >I'm a little late with this reply (car was stolen) but when I first got the
      >bits I put the TNMG on and went to cuttin, I guess I put too much pressure
      >on (it was cuttin well) and the whole end of the E tool broke off, I finally
      >found the incert unharmed, then I ordered the TT's (TCMM) and put them on
      >the other four I had left, I learned then about the 0 degree relief and the
      >7 degree, is it possible to run the tool a tad lower to be able to use the
      >TNMG?? I haven't them tried since I broke the tool, I brake enough stuff
      >when I try to do things to do the right way??

      I use TNMG, I made a toolholder with a 7 deg droop at the nose so the TNMGs
      then have an automatic 7 deg relief. Works for me and I get 6 cutting
      points.



      Committees of Correspondence Web page:
      http://www.geocities.com/CapitolHill/5357/
      - free men own guns, slaves don't
    Your message has been successfully submitted and would be delivered to recipients shortly.