Loading ...
Sorry, an error occurred while loading the content.

84010Re: [atlas_craftsman] new bearing races

Expand Messages
  • jerry Herrera
    Aug 21 7:37 AM
    • 0 Attachment
      If while removing the old bearing. If any material was removed would that cause a loose fit



      ------------------------------
      On Tue, Aug 20, 2013 10:05 PM PDT wa5cab@... wrote:

      >Seems to me that either the angle plate isn't perpendicular to the ways or
      >the cup isn't bottomed in the counterbored hole.
      >
      >In a message dated 08/20/2013 23:47:38 PM Central Daylight Time,
      >jerster1959@... writes:
      >> I setup a angle plate secured to the ways parallel to the spindle
      >> head.side view.
      >>
      >>
      >> ------------------------------
      >> On Tue, Aug 20, 2013 9:39 PM PDT wa5cab@... wrote:
      >>
      >> >From what "plate"?
      >> >
      >> >In a message dated 08/20/2013 23:13:52 PM Central Daylight Time,
      >> >jerster1959@... writes:
      >> >Hi guys, well my new Timkin bearings came. Set the spindle race in and
      >> >noticed that left to right has a difference of 0.010inches. Top to
      >> bottom.
      >> >What I did was set a steel plate parelle to the race and checked left
      >> and
      >> >right side. and top to bottom ,found that one side was .604 and the
      >> other
      >> >.614. From the plate. I probably can center it better but think once I
      >> install
      >> >the spindle with gears its going to move. So how criticle is it to get
      >> >these to zero. Will the taper bearings when tight just square anyway?
      >> Judt want
      >> >to get the center line as paralle to the bed wsys.
      >> >
      >
      >Robert Downs - Houston
      >wa5cab dot com (Web Store)
      >MVPA 9480
    • Show all 10 messages in this topic