Loading ...
Sorry, an error occurred while loading the content.

84008Re: [atlas_craftsman] new bearing races

Expand Messages
  • jerry Herrera
    Aug 20, 2013
    • 0 Attachment
      I setup a angle plate secured to the ways parallel to the spindle head.side view.


      ------------------------------
      On Tue, Aug 20, 2013 9:39 PM PDT wa5cab@... wrote:

      >From what "plate"?
      >
      >In a message dated 08/20/2013 23:13:52 PM Central Daylight Time,
      >jerster1959@... writes:
      >> Hi guys, well my new Timkin bearings came. Set the spindle race in and
      >> noticed that left to right has a difference of 0.010inches. Top to bottom.
      >> What I did was set a steel plate parelle to the race and checked left and
      >> right side. and top to bottom ,found that one side was .604 and the other
      >> .614. From the plate. I probably can center it better but think once I install
      >> the spindle with gears its going to move. So how criticle is it to get
      >> these to zero. Will the taper bearings when tight just square anyway? Judt want
      >> to get the center line as paralle to the bed wsys.
      >
      >Robert Downs - Houston
      >wa5cab dot com (Web Store)
      >MVPA 9480
    • Show all 10 messages in this topic