Loading ...
Sorry, an error occurred while loading the content.
 

Re: [Altair Computer Club] Re: Anyone here run a Dazzler as a piggyback board set

Expand Messages
  • B Degnan
    hope it works. let me know bd ... From: corey986 To: altaircomputerclub Sent: Thu, Jun 20,
    Message 1 of 5 , Jun 20, 2013
      hope it works. let me know
      bd


      -----Original Message-----
      From: corey986 <no_reply@yahoogroups.com>
      To: altaircomputerclub <altaircomputerclub@yahoogroups.com>
      Sent: Thu, Jun 20, 2013 4:43 pm
      Subject: [Altair Computer Club] Re: Anyone here run a Dazzler as a
      piggyback board set


      Bill,

      I found my answer by reading the schematics. I grabbed a 100 pin
      solder lug
      edge connector from a surplus place this week. Next week I can try
      putting it
      all together and see if I can save a slot.

      Cheers,
      Corey

      --- In altaircomputerclub@yahoogroups.com, B Degnan <billdeg@...> wrote:
      >
      > Corey
      > Did you get the answer you were looking for?
      > Bill
      >
      >
      > -----Original Message-----
      > From: corey986 <no_reply@yahoogroups.com>
      > To: altaircomputerclub <altaircomputerclub@yahoogroups.com>
      > Sent: Sun, Jun 16, 2013 9:08 am
      > Subject: [Altair Computer Club] Re: Anyone here run a Dazzler as a
      > piggyback board set
      >
      >
      > Well I decided to check the schematic. Looks like besides the
      obvious
      > +8 +16v
      > and ground, board #1 needs d0 0-3. Now I just have to think of how
      to
      > do this
      > and have it look clean and neat (the curse of using a clear plexi
      cover
      > on my
      > setup vs the metal top I have in storage.
      >
      > Cheers,
      > Corey
      >
      > --- In altaircomputerclub@yahoogroups.com, corey986 <no_reply@>
      > wrote:
      > >
      > > According to the instructions there are 7 wires that you will need
      to
      > connect
      > the boards and then you can piggyback board 2 on board 1 and save a
      > slot. This
      > would work out perfectly in my setup but I can't seem to find the
      > instructions
      > on doing the piggyback. I guess worst case I can look at the
      > schematics but
      > figured maybe the PDF I have for instructions could be missing
      > something.
      > >
      > > If anyone has done this or has instructions please let me know.
      > >
      > > Thanks,
      > > Corey
      > >
      >
      >
      >
      >
      > ------------------------------------
      >
      > Yahoo! Groups Links
      >




      ------------------------------------

      Yahoo! Groups Links
    Your message has been successfully submitted and would be delivered to recipients shortly.