Re: [V4Protocol] V4Chat 126.96.36.199 uploaded to Yahoo FTP and auto update server
- Rick,There are several ways to key the radio:1)With a SignaLink USB use the SingnaLink releay output to drive the radio PTT2) Use a separate dedicated RS232 port via signal DTR or RTS. (may require level shifter to key the PTT line of course)3) Use Radio control keying (e.g. Via CAT control) via serial port. Not useable on all radios.. I don’t recall off hand what the K3 uses or even if it supports CAT keying. I suspect it might use the same as the Kenwoods. One has to look into the control codes for the K3 or else try different combinations. Of course the baud rate of the control port must match the radio.4) True VOX on the radio (requires setting up for VOX operation and minimizing VOX delay)The help describes all 4 methods...one of which will always work. I generally prefer the SignaLink relay output to the Transceiver PTT.Maybe someone with a K3 can comment or let us know settings that work?Rick KN6KBHello Rick,Carl lives down the street from me and I did the initial install on his station - he is new to digital modes. He has a late model computers and HRD runs fine in all aspects but both V4 Chat and RMS Express exhibit the same symptoms - no keying of the K3 radio and no rig control with either case. Both programs installed easily with no errors.I have looked in Device Manager to see what ports to use and we are using the USB codec for his Signalink interface. So, I'm a little stumped here. His screens are virtual copies of what I am running on my station.Hopefully, you can help us.Another Rick - KH2DF
Sent from my iPhone
On Nov 30, 2011, at 8:33 AM, "Rick Muething" <rmuething@...> wrote:Carl,You need to be a bit more specific:e.g.Are you talking about playing the sound card? keying the radio? controlling the radio freq? or read back of the radio freq?What is your setup (sound card/interface, control and keying mechanism etc.)Are you trying to use the built in sound card...NOT recommended from almost all with any experience!Turn on the Debug log if not already on and try and duplicate the problem. Then send the log as an attachment with observed details and time (UTC) directly to me if possible.73,Rick KN6KB
I have not been able to get V4 to work on my Elecraft K3. Do you have any suggestions. I am also new to digital so I need detailed explanations.
Hope you all had a good Thanksgiving holiday...I enjoyed some time off and a visit with my sister.
I have uploaded an update to version 188.8.131.52. This should auto update for those with auto update enabled. The full install is posted on the Yahoo FTP as well. Generally minor but useful changes:
1) Now a "word mode" send command is available allowing a "send command" on each space. See the help and the new Setup menu. Several have asked for this and I do find it "comfortable" to send with.
2) Option to automatically send and log your qrid square on a connect. Also in the new setup menu. Checking AutosendGS will send your grid square upon an ARQ connection. This is also automatically logged into a "GRIDSQUARE" column of the ADIF log. This could be useful for contests etc. Again the updated help will explain.
Known remaining problems:
1) Problem with frequency read back on:
Early Icom's (specifically 735 and 765) basic problem is they don't seem to be adhering to the Icom CI-V commands as documented.
Yaesu Radios. I haven't been able to test this correctly yet. In process.
If you have serious problems please let me know. Be sure to enable debug logging.
I would be interested in setting up a V4 contest in the future. The auto GS logging in this new version could be used to compute points based on grid square, distance, etc.