Loading ...
Sorry, an error occurred while loading the content.

14116RE: Advice on Mikuni pump and B&S engine

Expand Messages
  • factoryfit
    Mar 7, 2014
      The stock location is off one of the rocker covers, but the racing people always block this off and run the pulse pipe to the inlet manifold.

      Next to the carb there's a casting blank to drill for fitting a hose barb. I pressed the one out of the rocker cover and used that, bonded it in with epoxy, drill smaller then clear 3/4 way down to a slip fit for the hose barb, then it can't fall in.

      On the marine version of the 35hp engine Briggs do this themselves at the factory, so they realise it needed doing to draw fuel any distance.
      Cheers

      Kev
    • Show all 13 messages in this topic