Loading ...
Sorry, an error occurred while loading the content.
 

Re: [SherlineCNC] About scale factor

Expand Messages
  • Peter Linss
    Not sure what you re asking, but the rotary table is 5 degrees per turn of the motor (or handwheel). So if you re using the Sherline CNC controller (4x
    Message 1 of 2 , Jan 31, 2006
      Not sure what you're asking, but the rotary table is 5 degrees per
      turn of the motor (or handwheel).

      So if you're using the Sherline CNC controller (4x microstepping)
      with the Sherline motors (200 steps per turn), then you have 160
      steps per degree (200 * 4 / 5).

      Peter

      On Jan 31, 2006, at 6:52 PM, caditout wrote:

      > did somebody know the scale factor of the rotary table on the sherline
      > controller
      >
      > thank
      > Claude
    Your message has been successfully submitted and would be delivered to recipients shortly.