37072Re: [SeattleRobotics] BotBoard cable pinout
- Nov 2, 2008
> 1. BotBoard cable pinoutThe schematic of the board has the pinout:
> Posted by: "Rich Chandler" rchandler@... mauser712
> Date: Sat Nov 1, 2008 7:58 pm ((PDT))
> I recently borrowed a BotBoard programming cable because it has a
> serial-TTL converter in it, for the purposes of reprogramming the eprom in
> my monitor. However, I need a pinout for the 4 pin connector on the end,
> and I havne't had much luck finding it. (LOTS of pages mention the thing,
> but I haven't seen a pinout yet).
> Anyone have a pointer for me?
This page has the pinouts:
This page describes the cable (assuming this is the one you have):
- << Previous post in topic Next post in topic >>