1039RE: [ScorbotUserGroup] computer won't communicate with robot [5 Attachments]
- Jan 8, 2014
You could try and Log into your Computer's BIOS at Startup
to make sure any SERIAL RS232 options are set to use COM1.
[Attachment(s) from connerd@... included below]
O.K. (frustrated sigh here)
Ordered, received, installed null modem cable.
Set COM1 as directed in manual (except I don't know where specified DIP switch is, if there is one Hmmmmm?).
Control box will operate all motors using "motor test" button.
Software operates fine.
But - any and all keyboard number/letter combinations that normally make robot motors move don't do anything. A "communication error" message is all I get on-screen.
Tried different settings for COM1 through device manager until I've run out of settings options.
Tried a "Cables-to-go" D25 to USB and its included drivers. Nothing.
Even installed a separate board from a company called PERLE but its options won't let me set it for COM1, interrupt 4, even with normal COM1 disabled.
A "tech" at parent company "Intelitek" told me last year that all I should need is a computer with Win98.
Intel Celeron 1.7 Gateway computer.
I know a little about C: prompts and MS-DOS, but just enough to be dangerous. Even tried booting in to MS-DOS and running - C:\scorbot\scor2 (level 2 was the last working level) with many different settings. Nothing but "communication error".
The last time it ran was off an ancient 486-based PC and the original cable was double ended D25. This computer finally just died and school tech guy said it was toast.
This email is free from viruses and malware because avast! Antivirus protection is active.
- << Previous post in topic Next post in topic >>