Re: [RoboMower] Lithium time!
- Is that English?
On 10 Feb 2013, at 17:01, "The CZ Unit" <cz@...<mailto:cz@...>> wrote:
Well, it's time to start building the packs for my Robomowers. I'm
thinking Lithium, 10-15ah capacity at 24 volts. Over the winter I have
converted my Roombas and Scooba to 18650 type cells, and they work *great*.
The BMS I am using is simple monitoring, it's up on Ebay, up to 8ah load
capability with per cell monitoring. Since the Robomower doesn't pull
that much current, a pair of 4 cell monitors should do it.
Anyone with thoughts?
NOTICE: The information in this electronic mail transmission is intended by CoralTree Systems Ltd for the use of the named individuals or entity to which it is directed and may contain information that is privileged or otherwise confidential. If you have received this electronic mail transmission in error, please delete it from your system without copying or forwarding it, and notify the sender of the error by reply email or by telephone, so that the sender's address records can be corrected.
CoralTree Systems Limited
25 Barnes Wallis Road
Segensworth East, Fareham
Company Registration Number 5021022.
12-14 Carlton Place
VAT Registration Number 834 1020 74.
[Non-text portions of this message have been removed]
- For the Roombas (14.4 volt packs) I went with eight Sony 18650 type
cells with 3.0ah capacity. These came out of some older Sony laptop
battery packs; "dead" usually means the batteries just drifted a bit.
However for the Robomower I would go with larger size cells, I was
thinking Headways at first, a 10ah cell would work pretty well, 8
needed. Or I could go with 10ah-15ah prismatics, not sure what would be
I like Lee's thought of using one big battery and a DC-DC, but the
problem there is the primary side would need to handle something like
80-100 amps to provide 10a on the output side. Does there exist a DC-DC
that could do this?
- On 2/10/2013 7:22 PM, The CZ Unit wrote:
> For the Roombas (14.4 volt packs) I went with eight Sony 18650 typeMore often, I find one of the cells (or parallel pairs of cells) has
> cells with 3.0ah capacity. These came out of some older Sony laptop
> battery packs; "dead" usually means the batteries just drifted a bit.
gone bad. The rest may still be good if you catch them soon enough
(before they go dead too, just from sitting).
> I like Lee's thought of using one big battery and a DC-DC, but the100 amp MOSFETs are only a couple dollars, and there are dozens of
> problem there is the primary side would need to handle something like
> 80-100 amps to provide 10a on the output side. Does there exist a DC-DC
> that could do this?
switchmode controller ICs that could be used. The main parts that
require careful selection are the MOSFET, output diode, and inductor.
If I were designing it, I'd build it as two twin converters, running out
of phase so one was on while the other was off. This minimizes input and
Also, since I know the boost ratio, the inductor would be tapped to act
as an autotransformer. This keeps the duty cycle on the MOSFETs and
diodes around 50% even though you're boosting about 8:1.
If we knew what we were doing, it wouldn't be called research, would it?
-- Albert Einstein
Lee A. Hart, http://www.sunrise-ev.com/LeesEVs.htm