Re: [RoboMower] new RL1000 - "Docking problem" message while going back to dock
- Make sure that you have "edge to dock" turned on in the menu.
----- Original Message -----
Sent: Thursday, May 31, 2007 2:35 PM
Subject: [RoboMower] new RL1000 - "Docking problem" message while going back to dock
I just setup a new RL1000. All's well, except while going over some
bumpy ground (roots, pine cones, etc) as the mower is following the
perimeter wire while going back to the dock, it stops and displays
I seem to remember my older mowers have a service menu option to
ignore the front wheel up sensor while looking for the dock, but I
can't find it (or the service menu for that matter) on my new mower.
[Non-text portions of this message have been removed]