Loading ...
Sorry, an error occurred while loading the content.

18780Replacement of wire sensors

Expand Messages
  • w_d_dresser
    Jun 2, 2014
    • 0 Attachment

      I have a RL1000 and an old RL550 that I now use for parts where I can.  Is there any reason why I should not snip off one wire sensor from the RL550 to replace a failed wire sensor on the RL1000?  I would prefer just to take one rather than the whole set of four, just to maintain three spares.

      Also, does anyone know why these wire sensors fail?  This is the second time I have had the problem.

      Thanks, Don