Loading ...
Sorry, an error occurred while loading the content.

17308Re: [RoboMower] Re: Overrun

Expand Messages
  • jeff
    Sep 9, 2010
      My 850 will do that is falls off the lawn adn the beauty bark and eroded or been
      pushed back. I merely build the bark back up and works fine then. Look for a
      fall off point and raise it




      ________________________________
      From: toolman_d <toolman_d@...>
      To: RoboMower@yahoogroups.com
      Sent: Thu, September 9, 2010 2:41:41 PM
      Subject: [RoboMower] Re: Overrun

       
      I've observed the mower overrun the perimeter:
      1) when the battery is low/drained
      2) there are cars parked close to the perimeter
      3) on a hill when the rear tire drops off the edge of the grass (the mover
      pivots outside the perimeter)

      --- In RoboMower@yahoogroups.com, Danny Miller <dannym@...> wrote:
      >
      > Go under Service. There's a "Learn Wire Sensors", also a "Test wire
      > sensors" IIRC. You need to have the mower inside an active perimeter wire.
      >
      > Danny
      >
      > Ken Hawn wrote:
      > > My mower will sometimes jump the perimeter wire, it will stop within 3 feet.
      >I just pull the battery box out and wait a minute or two and replace it. That
      >seems to reset something and then It works fine.
      >
      > > Ken
      > >
      > > Sent from Ken Hawn's iPhone
      > >
      > > On Sep 1, 2010, at 3:23 PM, "Douglas B. George" <dg@...> wrote:
      > >
      > >
      > >> My RoboMower has started running over the wire. It always happens in the
      > >> forward direction. This never used to happen, but now it does that on
      >perhaps
      >
      > >> every fourth run of the mower.
      > >>
      > >> Usually it just gets stuck but in one instance I actually saw the mower
      >leave my
      >
      > >> property altogether. I chased it down as it went merrily on cutting grass
      >next
      >
      > >> door! I'm sure it would have stopped eventually but that is not good!!!
      > >>
      > >> It looks like there might be several wire sensors around the perimeter of
      >the
      >
      > >> mower, and maybe one of the front ones isn't working(?). Any suggestions on
      >how
      >
      > >> to diagnose and repair this issue?
      > >>
      > >> Thanks,
      > >>
      > >> Doug
      > >>
      > >>
      > >
      > >
      > > [Non-text portions of this message have been removed]
      > >
      > >
      > >
      > > ------------------------------------
      > >
      > > Yahoo! Groups Links
      > >
      > >
      > >
      > >
      > >
      >
      >
      >
      > [Non-text portions of this message have been removed]
      >







      [Non-text portions of this message have been removed]
    • Show all 18 messages in this topic