SOLVED - [Raspberry_Pi_4-Ham_RADIO] JNOS 2.0j.2 on RPi: tun device problem
- Simple fix. I was writing in "TUN1" to the autoexec.nos in place of "TUN0" which had been used successfully on another machine. That was evidently the cause of the problem. For some reason, jnos only want's to see a TUN0 designation OR linux wants to see a TUN0 before there is a TUN1. At any rate, using TUN0 gets rid of the error messages.
On Sun, Dec 30, 2012 at 6:22 PM, KD6OAT <kd6oat@...> wrote:Thanks Jerome. I tried modprobe early in my investigation but without success. IPV4 forwarding appears okay and jnos runs okay except for tun. I run it as root.
On Dec 30, 2012, at 5:41 PM, jerome schatten <va7vv@...> wrote:
Try 'modprobe tun' before you bring up jnos and see if that works.
BTW... I've just managed to get everything compiled and running with no errors under jnos2j.
Also... are you running as root? Were you able to turn on ipv4 forwarding with
'sudo echo 1 > /proc/sys/net/ipv4/ip_forward' I could not do it with sudo, but I could in a root terminal. Very strange!
jerome - ve7ass
--- On Sun, 12/30/12, kd6oat <kd6oat@...> wrote:
From: kd6oat <kd6oat@...>
Subject: [Raspberry_Pi_4-Ham_RADIO] JNOS 2.0j.2 on RPi: tun device problem
Date: Sunday, December 30, 2012, 3:31 PM
Hello all. I just complied JNOS on my raspberry Pi which is running debian wheezy. For some reason, when I run jnos, I get the following error message:tun1: ERROR while getting interface flags: No such deviceI checked /dev/net/tun to make sure tun was present - which it is - but evidently the lines of instructions in the autoexec.nos file are not creating tun1 (the exact same lines work just fine under Ubuntu on a different machine).I've been running through numerous threads after googleing but am coming up empty so far. Any suggestions are appreciated.73~Ken