Re: [RTrak] RTrak-HAB antenna thoughts
- On 9/6/2012 12:54 PM, James Ewen wrote:
Let me guess, you're basing this opinion on data gleaned from the
APRS-IS stream where only a small portion of the data is available.
No, he's basing that opinion on the fact that he and I were in an APRS QSO while the balloon was in flight and there were numerous RF-enabled APRSISCE/32 instances well within the balloon's footprint but his was the ONLY station report ANY receptions of the balloon.
In every other HAB I've monitored, even pre-APRSISCE/32's unfiltered RF feed, at least a FEW packets would get far enough out to hit a delaying gate and show up with a line or two. In this case, every single packet was gated by his mobile IGate alone.
I'd suggest just taking the balloon's tracker out and see if any device other than the mobile (what was the radio in your mobile IGate anyway) receives it.
Lynn (D) - KJ4ERJ - Author of APRSISCE for Windows Mobile and Win32
PS. His mobile IGate was also gating stuff for many stations around, not always first.
- Ben KF7VZR (got that from a June 22 message) wrote...
> My documentation says nothing about TX audio level...Deviation is important. If it's too high (within limits) nearby stations
> They've both been played with...
may still be able to decode the tones. Distant ones where your signal
is weaker may not be able to. You have probably heard this on a voice
repeater or even on simplex. A distant and noisy station can be copied
via a repeater if he backs off from the mic. If he starts shouting, the
deviation goes up. More energy is outside the passband of the receiver
and eventually the signal is too noisy to copy or the squelch might
even close. If you are simplex, you can try opening your squelch. If
you are on a repeater, you're out of luck. It's the same with packet.
You are better off having the deviation set properly. It can be done
by ear, but a deviation meter or service monitor would be better.
Lacking one, just crank the deviation all of the way up and then
start turning it down. When it starts to sound quieter, turn it down
some more. It will get you in the ballpark, but checking the actual
deviation would be better.
Perhaps you could check the actual deviation before you change
anything. So... could over-deviation explain why only one iGate
73 es cul - Keith VE7GDH
"I may be lost, but I know exactly where I am!"