RTrak-HAB antenna thoughts
I'm preparing my first balloon launch and trying to decide on antennas for the mobile ground station as well as the balloon. I'm a new ham, and nervous about keeping a strong enough signal over 25-30 miles with just 350mw transmit power and random orientation. Suggestions?
For best front-to-back ratio there are some really neat antenna designs (patch, bi-quad with reflector, yagi, 2 and 3 element quad) but they aren't very conducive to balloon work!
For those of you who've done this before, what are your recommendations? I'm sure I'm over-thinking it, so I'd love to hear what others have done with success.
- Ben KF7VZR (got that from a June 22 message) wrote...
> My documentation says nothing about TX audio level...Deviation is important. If it's too high (within limits) nearby stations
> They've both been played with...
may still be able to decode the tones. Distant ones where your signal
is weaker may not be able to. You have probably heard this on a voice
repeater or even on simplex. A distant and noisy station can be copied
via a repeater if he backs off from the mic. If he starts shouting, the
deviation goes up. More energy is outside the passband of the receiver
and eventually the signal is too noisy to copy or the squelch might
even close. If you are simplex, you can try opening your squelch. If
you are on a repeater, you're out of luck. It's the same with packet.
You are better off having the deviation set properly. It can be done
by ear, but a deviation meter or service monitor would be better.
Lacking one, just crank the deviation all of the way up and then
start turning it down. When it starts to sound quieter, turn it down
some more. It will get you in the ballpark, but checking the actual
deviation would be better.
Perhaps you could check the actual deviation before you change
anything. So... could over-deviation explain why only one iGate
73 es cul - Keith VE7GDH
"I may be lost, but I know exactly where I am!"