Loading ...
Sorry, an error occurred while loading the content.

cat control for ROS and Yeasu FT-920

Expand Messages
  • DAVID
    when using Yeasu FT-920 cat control with ROS, the DATA mode is always selected, vice the SSB mode. when DATA mode is selected, the IF is shifted up about
    Message 1 of 2 , Jan 14, 2012
    • 0 Attachment
      when using Yeasu FT-920 cat control with ROS, the DATA mode is always
      selected, vice the SSB mode.

      when DATA mode is selected, the IF is shifted up about around 500hz. so that using ROS or sstv, the entire signal can not be used for either RX or TX.

      so to use ROS, it is necessary to rewire the audio cables and use the microphone input vice the DATA input on real panel.

      so i am asking for a small change in the CAT control code or somewhere in ROS to allow the selection of SSB or DATA.

      david/wd4kpd
    • Jan-Olof Nilsson
      Use DATA-USB for ROS operation. To activate this mode of operation, the front panel Mode selection must be set to DATA-USB (even though “USB” may not be
      Message 2 of 2 , Jan 15, 2012
      • 0 Attachment
        Use DATA-USB for ROS operation.

        To activate this mode of operation, the
        front panel Mode selection must be set to
        DATA-USB (even though “USB” may not be
        the actual sideband utilized in operation), and
        the rear panel AFSK-FSK switch must be set
        to AFSK
         
        73 de sm0ifp
        /Jan-Olof Nilsson
        +46 736 780513
        +46 8 4477601

        Ordförande/President
        SödRa - Södertörns Radioamatörer - SKØQO
        Box 188
        136 23 HANINGE
        Plusgiro: 68 05 89-9
        http://www.sk0qo.se
      Your message has been successfully submitted and would be delivered to recipients shortly.