Re: Need help with setting image parameters for circular images
- --- In PanoToolsNG@yahoogroups.com, "gobrien1911" <gary@...> wrote:
> Crop circle is set identically for all images.If you look on the Source Images tab, you should see all the image
> I thought the sensor orientation might be the problem, so I changed
> the roll in 90 degree increments. Doesn't seem to work.
thumbnails in the same orientation. If any image is upside down, that
may be evident by inspecting the positions of the crop circle, which
has been set the same on all images. Often, the lens axis is not
precisely aligned with the centre of the sensor. This leads to an off-
centre image circle. When an image is upside down relative to the
other images, the crop circle then won't align accurately with the
image circle. This causes problems in optimization.
> I have to confess I know how to push the buttons in PTGui, but I'm notIf you have different crop circles on the nadir/zenith, you must select
> clear on what actually happens. When you say select individual lens
> params for the cropped Z and N, do I need to change other params
> beside pitch for those cropped frames?
individual lens parameters - i.e. fov,a,b,c,d,e. If you reduce the
size of the crop circle, you decrease the fov of the (cropped) image.
Assigning +90 to the pitch of the zenith image merely positions it at
the top of the stitching sphere. It will appear to spread out across
the top of the equirectangular output image. Varying yaw or roll
values will rotate it in that position. Of course, assignment of
control points and optimization will locate the zenith image in its
correct position anyway.