Lines in the Pano
- Hi All,
I believe I recently read a thread on what may have caused a visible
line in the finished Pano. I have had this happen to me in the past
and thought it was a problem with PanoCube, but I believe, from
reading this recent thread, it was occurring due to a step that I was
performing in PS. I don't see it all that much and until this recent
thread I couldn't figure out why some of my pano's had a line at the
corner of a cube face and some did not. I recently saw this line
again. Could someone remind me as to what the cure was. I believe it
was either to "flatten" the image layers or "merge" the image layers
caused the "line". I am not quite sure how doing the steps
differently would matter but if someone could remind me once again it
would be much appreciated.
Thanks in advance,
> I believe I recently read a thread on what may have caused a visibleYour memory serves you well. Flatten the image before resizing and/or
> line in the finished Pano.
sending it to Pano2QTVR and you're all set. Of course, that assumes
that your image size is fully a 2:1 ratio as well, double check that.