Loading ...
Sorry, an error occurred while loading the content.
 

Re: PTStitcher / Nona / PTMender ...

Expand Messages
  • dmgalpha
    ... Ok, I get it. It was really a problem of user interface. From the command line PTmender should not have this problem (even in older versions). I believe
    Message 1 of 26 , Mar 7, 2007
      --- In PanoToolsNG@yahoogroups.com, "Erik Krause" <erik.krause@...> wrote:
      >
      > On Tuesday, March 06, 2007 at 22:51, dmgalpha wrote:
      >
      > > The FOV does not apply to the output projection but to the input image
      > > (iff fisheye or gnomonic; you can use FOV > 180 with equirectangular
      > > input)
      >
      > apparently not. I choose a 360° equirect as input in hugin and go
      > straightly to Stitcher tab. If I choose fisheye as output there, FoV
      > is reduced to 179°. If I enter a higher value I get a message that
      > "Maximum FoV for this projection is 179.000" (0.7 beta 4)
      >
      > I was wrong for the stereographic projection, where the message
      > reads: "Maximum FoV for this projection is 340.000" (which certainly
      > is enough for "little planet").
      >


      Ok, I get it. It was really a problem of user interface. From the
      command line PTmender should not have this problem (even in older
      versions). I believe you can map a 359 degrees stereographic, but it
      will probably be useless.


      dmg
    Your message has been successfully submitted and would be delivered to recipients shortly.