Re: Boxcar Base
- Just some information:
Besides manufacturing magnetic flatbases and magnetic cylinders for
the printing industry, Bunting actually makes non-magnetic cylinders
for use with polyester-backed platesand has for a "lot" longer than
"boxcar plates" have been around. They never manufactured a
non-magnetic flatbase though, I assume, market-wise, they saw no
industry support since non-magnetic flatbases were readily available.
I had a bunch of the old plastic newspaper bases at one point, and
they were also made from type metal and wood (I have some very precise
aluminum combination base material that was manufactured in Germany).
Those old AWT and ATF catalogs list all sorts of base material.
> > By "boxcar plate," do you mean you are using a polyester-backed plate
> > w/film adhesive on a Bunting Magnetic base? If so, what is the
> > rationale?
> Yes we use polyester-backed plates w/ film adhesive (a whole lot
> easier to say boxcar plate), but it's not on a magnetic base, its
> just an aluminum base. I don't know why I said bunting.
> But, even on a magnetic base I would use boxcar plates (and have
> before, on other people's setup) and just adjust the press
> accordingly, for a number of reasons, though mostly for quick
> registration (we tape the plate upside down to the paper, properly
> registered, and then run it through the press).