Loading ...
Sorry, an error occurred while loading the content.

Re: [PPLetterpress] Laser Engraving

Expand Messages
  • Erik Desmyter
    on http://www.epiloglaser.com/materials.htm under engraving you can read: With adjustable speed and power settings from 1 to 100% and dpi settings of up to
    Message 1 of 2 , May 11, 2002
    • 0 Attachment
      on http://www.epiloglaser.com/materials.htm under engraving you can read:

      "With adjustable speed and power settings from 1 to 100% and dpi settings of
      up to 1200, you can set the engraver to print with as much depth and detail
      as you need"

      and under laser basics:

      "vector cutting is a continuous path that follows the outline, or profile,
      of an image. Vector cutting is normally used to cut completely through
      materials such as wood, acrylic, paper, etc. It can also be used for quick
      marking of characters and geometric patterns."

      "It is possible to mark bare metal with a low power CO2 laser system using a
      two step process. Simply apply a metal marking solution, such as Cerdec, to
      the metal and let it dry. Laser engrave you image onto the metal, and wash
      off the solution for a permanent metal mark. "

      "The Legend line of laser engraving and cutting systems can engrave at
      resolutions ranging from 200 to 1200 DPI"

      "higher power will produce deeper cutting or engraving. Adjustable in 1%
      increments, the power can be controlled either from your computer or from
      the control panel on the engraver"

      1200 dpi, variable depth, vector cutting all sounds interesting

      Rgds,
      Erik
    Your message has been successfully submitted and would be delivered to recipients shortly.