Re: Roller Supports
- --- In PPLetterpress@yahoogroups.com, "Austin Jones" <austin@...> wrote:
>Press. [. . .]
> I just wanted to mention that I use Bearers regularly on my Bobcat
> I am just attempting to make the point that Bearers have been aroundIndeed, Austin. I jumped into this thread so people wouldn't get the
> for a long time for use on this type of press.
idea that those .918" strips just supported the rollers. The same
object can be used to compensate for two different problems (in inking
and impression), and be described differently or ambiguously (bearer
or roller support or roller bearer). How effective they are for either
problem depends on how they are used, and there are many
possibilities. If, as Gerald says, you cut away the packing, then they
won't affect impression and are just roller supports.
A handpress printer might use both platen bearers and roller
supports. I get the idea you're inking with balls and don't have a
need for roller supports. I've seen platen bearers placed in the four
corners, and also roller supports closer to the form, with packing cut
away. Platen bearers have also been used to compensate for off-center
or unbalanced forms on mechanized platens.
But if you place bearers in a proof press form and don't alter the
packing, they will definitely contribute to a more even impression,
something necessary in a foundry/hot-metal repro situation.
--Eric Holub, SF
- Eric makes a good point. Bearers can be used for a multitude of problems.
They can cause problems with impression if not used properly.
It is always important to understand the relationship between type, ink
rollers, and platen. Any change in either requires a change in the others. I
do more packing behind type than on the platen. I use a variety of type
fonts. to set up reprints of old broadsides. This type will vary in height
quite often. My logic - I want the type to be level on top where it comes in
contact with the ink rollers. I don't care if the feet are even. Packing for
uneven type on the platen serves the same purpose. I like to get the
majority of the type inking evenly, then adjust the feet to bring the type
up to being even. It will now ink even. Platen packing is now obvious.
I print on flatbed presses quite often with hand brayers. I have never found
bearers necessary. I use heavy brayers. The brayer has a large core of metal
which controls the weight and pressure. By using a Brayer with a consistent
weight, the pressure is consistent. I never apply pressure to the brayer,
just allow it to ride over the type or image. Perhaps if I were printing
large expanses of small type I might find a need to support the brayer in
I think that most of this discussion makes the point that all printers need
to completely understand the process, equipment, media, and environment
before applying ink to spatula.
prints by AJ
Point Pleasant, WV
----- Original Message -----
From: "parallel_imp" <Megalonyx@...>
Sent: Monday, September 15, 2008 2:04 PM
Subject: [PPLetterpress] Re: Roller Supports
> --- In PPLetterpress@yahoogroups.com, "Austin Jones" <austin@...> wrote:
>> I just wanted to mention that I use Bearers regularly on my Bobcat
> Press. [. . .]
>> I am just attempting to make the point that Bearers have been around
>> for a long time for use on this type of press.
> Indeed, Austin. I jumped into this thread so people wouldn't get the
> idea that those .918" strips just supported the rollers. The same
> object can be used to compensate for two different problems (in inking
> and impression