7930Re:Advice on ink coverage
- Jun 11, 2007Another possible explanation may be a difference of pressure on different
parts of the form. I have not printed with the Model press, but with many small
table-top platen presses, packing in one part of the form affect pressure
elsewhere in the form. The reason is that the platen is hinged quite close to
the form, so as packing is added it will bring the bottom edge of the platen
closer to the type than the top edge. So to keep the platen parallel to the
type and the pressure even, the lower bolts have to be loosened as packing is
added (or the top bolts tightened).
What I am suggesting is that as you adjusted the packing to get the larger
type to print correctly, at the same time you were actually reducing the
pressure on the other type.
You might be able to check this by examining the back of the sheet - to see
if all parts of the type form are hitting with the same pressure. If it is
hitting harder at the edge closest to the hinge, this may be the trouble.
Of course it could be any of a dozen other factors! -- ink, rollers, plate,
backing block, paper, etc. Another common cause might be that the rollers are
hitting the type ok on the large surface of the 24 point type, but actually
squashing the ink off the surface of the smaller type (leaving weak inking on
the small type but perhaps a rim of ink around the letters). The solution
for that would be to raise the rollers, with tape on the tracks, so the rollers
don't hit the type too hard.
Or any of the other suggestions may be the answer.
Multiple possibilities, multiple tricks.
Now It's Up To You Publications
157 S. Logan, Denver CO 80209
(303) 777-8951 home
(720) 480-5358 cell phone
************************************** See what's free at http://www.aol.com
[Non-text portions of this message have been removed]
- << Previous post in topic