Loading ...
Sorry, an error occurred while loading the content.

3761Re: [PPLetterpress] Circular quads

Expand Messages
  • typetom@aol.com
    Feb 10, 2005
      Hi Barb,
      One method is to put a strip of tape on the inside edge of the curve before
      you curve it, so the spacing at that edge stays tight. Then lock it with normal
      lock-up pressure in the circular quads, adjusting the angles of the type as
      needed. I don't think you have to fill all the angled spaces that are left --
      as long as it holds.

      Tom Parson
      Now It's Up To You Publications
      157 S. Logan, Denver CO 80209
      (303) 777-8951

      [Non-text portions of this message have been removed]
    • Show all 12 messages in this topic