Loading ...
Sorry, an error occurred while loading the content.

12936Re: dots moving

Expand Messages
  • Gerald Lange
    Dec 30, 2011
    • 0 Attachment

      If you need bulbs go here:

      Santa didn't bring me a new platemaker either. What's up with that? I guess we weren't on the good boys' list.

      A couple of small miracles and positive transitions though so ready for 2012 with my bear claws on.

      Let's go!


      --- In PPLetterpress@yahoogroups.com, Ian Bristow <ductormanpaperboy@...> wrote:
      > Thanks everyone for the advice. I'm pretty sure your right about the room temp Gerald as I was processing while my shop was heating back up.
      > These harsh Canadian winters do not help!!! I also had the plates leaning up against a cold wall. I will make sure I bring the heat up in the shop first
      > and try again. I have also used the 95 plate material with o.k. results, I find it is often hit and miss with my platemaker. She does the trick most of the time
      > but by no means the cadillac of platemakers (jerry rigged polimero unit). I think the problem is the fluctuating shop temperature and the light source.
      > Santa never brought me a new platemaker!!!
      > Thanks again
      > Happy New Year!!!
      > Ian
      > We Do Printing
      > http://wedoprinting.wordpress.com/
      > www.wedoprinting.net
    • Show all 8 messages in this topic