Re: microKeyer/FT1000MP Mk V CW problem
- Hi Joe & the group -
Thanks for your help.
PTT is working in CW, SSB, and RTTY (sort of). In RTTY, I can key
the rig and hear tones if I click on the TX button in the MTTY/PSK
window. I can transmit RYRYRY from this window also. Clicking on the
presets on the bottom of the DI1 window has no effect.
I can't get anything to transmit, or PTT to activate from the VFO A
window in N1MM - probasbly because I get an error: Can't open Port
5. In Configure Ports in N1MM, I have Digital & Other checked; DTR
Always Off, RTS PTT, Allow Exit interupts checked, PTT Delay 10,
CW/PTT 2F0, Radio 1. N1MM digital Modes Configurer, Interface 1
Type MMTTY/PSK; Normally MMTTY window checked, DI-1 Mode FSK. BTW,
when I enter RTTY in VFO A, the radio does switch to RTTY & LSB. In
the N1MM DI1 Window, Setup, Setup MMTTY, TX Tab, PTT Port is COM 5;
Radio command button, Port Definition - Port None. On the Misc. tab,
TX Port is Sound+Com-TxD(FSK); USB Port set to C - Limiting Speed.
On the Microkeyer, Ports, FSK: COM 5, opem, 45 5N1.5. The green/red
arrow and the Test button are both greyed out. PTT: COM5, RTS,
open, arrow indicator and test button greyed out. Microkeyer
PTT/FSK tab, FSK PTT2 delayed; set to 20 ms.
On the N1MM RTTY Engine 1, TX keys the rig and sends tones.
Entering DIGI into the VFO A window changes the mode to PKT on the
window, and PKT+LSB on the FT1000. I have to change the Digital
Interface mode manually to PSK. Clicking on the TX button in the
DI1 or PSK Engine window causes the rig to key, and a tone to be
sent. Clicking on any function key does nothing.
I'd really appreciate any suggestions.
--- In N1MMLogger@yahoogroups.com, "Joe Subich, W4TV" <w4tv@m...>
> Do you have the proper virtual port/control line set for PTT in
> Router? Have you restored your N1MM preset? Have you configured
> the updated N1MM installation to match the old one?
> ... Joe Subich, W4TV
> microHAM America, LLC
> > -----Original Message-----
> > From: N1MMLogger@yahoogroups.com
> > [mailto:N1MMLogger@yahoogroups.com] On Behalf Of wb2nvr
> > Sent: Wednesday, August 31, 2005 8:43 PM
> > To: N1MMLogger@yahoogroups.com
> > Subject: [N1MM] microKeyer/FT1000MP Mk V CW problem
> > I just downloaded the latest N1MM, and also updated my
> > interface to the latest version. I'm using these with ancan't get
> > FT1000MP MK V. I can send CW by using the Send CW drop down
> > window. I can also turn
> > TX on and off using the TX and TXOFF of the RTTY window. I
> > the rig to go into transmit by using the function keys in anymode.
> > Does anyone have any suggestions as to where I might have made a
> > mistake with the setup? TIA.
> > 73,
> > Bob WB2NVR