Loading ...
Sorry, an error occurred while loading the content.

13316Re: Engine Question

Expand Messages
  • vexatious2001
    Aug 4, 2006
    • 0 Attachment
      I
      > > tried to straighten the pieces with a three foot 1/4" dowel rod
      > with little
      > > success.
      >
      >
      >
      >


      One other suggestion: try using a 1/2 inch dowell
      rod, which is much closer to the diameter of the
      driveshaft, and leave the rod inserted until the
      motor is upright and vertical, and you are ready
      in install the lower unit.

      You might need to carve a bit of chamfer on the
      tip of the 1/2" rod.


      Max
    • Show all 11 messages in this topic