Re: hd-hg400lan hardrive replacement procidure
- --- In LinkStation_General@yahoogroups.com, "musikgoat"
>I forgot to mentioned that when I get the error the "disk Ful"and the
> --- In LinkStation_General@yahoogroups.com, "alphaomegared35"
> <alphaomegared35@> wrote:
> > --- In LinkStation_General@yahoogroups.com, "lalunas10"
> > <lalunas10@> wrote:
> > >
> > > --- In LinkStation_General@yahoogroups.com, "alphaomegared35"
> > <alphaomegared35@>
> > > wrote:
> > > >
> > > > the harddrive of my hd-hg400lan went bad and I have to replace
> it. Can
> > > > some one tell me how to install the new drive. What type of
> programs I
> > > > have to install, formatting, partitioning, etc. Any information
> > > > be appreciated. Thanks
> > >
> > > The new HDD must be unpartitioned. Flash the firmware twice. The
> > first run will create the
> > > partitions etc., the second the 'visible part'.
> > >
> > > -A
> > Thank YOu for the info, I did the firmware and it did created
> > everything just like you said. I just ran into a problem during the
> > procedure, the drive froze and the "DISK FULL" light came one...and a
> > message popped out that "firmware installation failed". I tried to
> > access the drive through the ip address and no luck. Does the firmware
> > installs the web interface too? What can be the problem?
> > Thanks in advance...
> > >
> What kind of hard drive did you replace it with.
> The first flashing of the firmware should fail. THen you want to run
> the updater again, and it should install the web interface and all the
> software to make it run.
> What exactly have you done thus far?
"Diag" ligths start flashing...