I am using a NETGEAR GIBABIT ROUTER, and
I have my Linkstation set to 9000K Jumbo Frame.
If you NIC supports jumbo frame, LEAVE THAT SETTING OFF.
it wont work properly.
--- In LinkStation_General@yahoogroups.com
> Hi all,
> While tooling around the menus in my KuroBox HG, and without
> things through fully... I thought I'd try the Jumbo Frame setting,
> both my KB and my computer are 1000mg Lan capable. Of course I
> instantly lost access to my KB, as my network hub is not JumboFrame
> Is there any way to get back into my KB to reset it to standard
> The 10/100 hub/modem from my service provider is acting as the DHCP
> server on my network, between my KB and my desktop running
> Center2005. Two ideas:
> (i) Is it possible to connect to the KB directly from my desktop
> crossover lan cable? (Remember, currently IP addresses are
> my network via the DHCP server in my modem/hub).
> (ii) If I purchased a 10/100/1000 JumboFrame-capable switching hub,
> cascaded that off of the hub/modem from my provider, would that
> access to my KB again?
> TIA for any suggestions!