Re: LinkStation 120
- as long as the hdd isn`t damaged you should be able to recover your box.
1) open you LS
2) connect the hdd to your workstation and wipe all partitions on it
3) put the blank hdd back into the box and boot
4) flash the box twice with openlink
--- In LinkStation_General@yahoogroups.com, sfseay@... wrote:
> I posted here earlier about a problem with an OpenLink firmware
> upgrade and somebody asked what I was seeing.
> The diag light is flashing 6 times repeatedly when I try to power the
> unit up.
> Again, I followed the instructions to upgrade my firmware with
> OpenLink, ran the program to upgrade the LinkStation, got a message
> the upgrade worked and I should reboot the Linkstation,
> then I am seeing the blinking red light above.
> I'm sure it is toast, however I'm open to any ideas.